Well, the question isn't really about the SSD in general.
I have an ASUS ROG Rampage III Black Edition w/ the latest & last firmware for the board, I installed the SSD as well as the 2TB HDD to the SATA 6Gb ports on the mobo. After the ROG logo, I see a screen for Marvell, and after that I see a screen mentioning JMicron, and that there's no drive. What is up with that, and how do I get rid of it?
Also, I've upgraded the firmware to the latest: 1.05; which also appears to be the last.
When booting up, ASUS' BIOS reports that the SSD is in S0 and the HDD is in S1 -- this is part of the Marvell screen -- but the upgrade tool reported the same thing, and first tried to see if the HDD was the SSD because it was in S1 and didn't pass, but then it saw the SSD in S0 and started the upgrade.
So, my question is this:
Should I switch the SSD to S1 and the HDD to S0?
Also, when in Windows, both the SSD & HDD appear under the "Safely Remove Hardware", what the hell is up with that?
(I don't know if I should also post this to the mobo section of the forum as well).