Some of the more major companies that produce superglue, normally list the maximum hit resistance of the glue. The ramsinks on my latest vid card were attached with this...
http://www.krazyglue.com/products/produ ... ?prodID=25
Here is the Material Safety Data Sheet on this glue.....
Basically, here are the main points that should inform you wether to use it or not.....
9. Physical and Chemical Properties
Percent Volatiles Not determined
pH @ 25 C Not available
Specific Gravity 1.05
Appearance Colorless liquid
Autoignition Temperature 485 deg C
Boiling Point 62 deg C (5 mm Hg)
Vapor Density (Air=1) > 1
Vapor Pressure, mm Hg @ 20 C 0.13
Evaporation Rate (Butyl Acetate=1) < 1
Upper/Lower Flammable Limits Not available
Up/Lower Explosive Limits, % by Vol Not available
Flash Point 83 deg C (CC)
Freezing Point < -20 deg C
Odor Threshold, ppm Not available
Solubility in Water Negligible
Coefficient of Water/Oil Distrib. Not applicable
10. Stability and Reactivity
Normally stable, but may become unstable at high temperatures or may
react with water.
* Conditions to Avoid:
Exposure to heat, flame and incompatibles.
as long as the heat conditions produced by the ram are within the limits tolerated by the glue; according to the MSDS, you should be fine.
Every single one of the products made by Krazy Glue, come with a MSDS on their site. I would imagine that any company that produces adhesives, and has a product site, should also have the MSDS's provided on the site.